New Page 0

We manufacture a small range of Sun dials, bird baths and staddle stones for domestic and commercial use, we detail below our range of standard products, if you need any advise or information you are welcome can contact us on 01829 770 632, or you can contact us by email on the link above

All of the products below are available in seven standard stone finishes (composite stone) or colour matched to existing (subject to a minimum quantity)

you need help please contact us on Tel: 01829 770 632 or fax 01829 770642

Click products to enlarge the detail

The traditional staddle stone is shown here in a Gritstone finishes, originally used to support timber floors and buildings for the storage of grains, thereby protecting the crop from rodents, now used as ornamentation lining drives and paths

Height: 660mm (26”)

A Georgian style sundial and bird bath with fluted shaft, shown here in our

Portland stone finish and gritstone finish, the numerals are engraved into the surface of the

Sundial top with the brass gnomon fitted. Height 725mm (28.5”)

The Armillary is shown in our popular Portland stone finish on our P2 pedestal. A stylish and fashionable piece that will take centre stage in gardens and on patios, Pedestal Height: 800mm Width:450mm

Armillary globe

Diameter; 510mm

This reproduction 17th century sundial is shown in an artificially aged red sandstone finish, this moulding was taken direct from the original sun dial , a most impressive sun dial, it is supplied un-assembled only, and must be fixed by a competent tradesperson.

Height: 1200mm (47”) Width at base: 550mm (211/2”) Diameter at top 400mm (153/4”)

BIRD BATH STADDLE STONE

The traditional staddle stone, shown here in a Red sandstone finishe, originally used to support timber floors and buildings for the storage of grains, thereby protecting the crop from rodents, now used as ornamentation lining drives and paths

Height: 660mm (26”)

A Georgian style sundial and bird bath with fluted shaft, shown here in our Portland stone finish the numerals are engraved into the surface of the Sundial top with the brass gnomon fitted.

Height 725mm (28.5”)